| BMW Inspection I |
| Undercarriage |
| 1.Change engine oil and filter while engine is at normal operation temperature. |
| 2.Check transmission for leaks. |
| 3.Check rear axle for leaks. |
| 4.Visually check fuel tank, lines, and connections for leaks. |
| 5.Check condition, position, and mounting of exhaust system. Examine for leaks. |
| 6.Check power steering system for leaks. |
| 7.Check overall thickness of front and rear disc brake pads. |
| 8.Examine brake disc surfaces. |
| 9.Clean brake pad contact points in calipers. |
| 10.Grease wheel center hubs. |
| 11.Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc. |
| 12.Check front control arm bushing for wear. |
| 13.Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning. |
| 14.Check for free movement of the parking brake cables. Adjust parking brake if necessary. |
| 15.Check all tire pressures (including spare). Correct if necessary. |
| 16.Check condition of tires (outer surfaces (left/right)), tread wear and pattern; In case of uneven tread wear readjust wheel alignment if required. |
| Engine Compartment |
| 1.Read out diagnostic system |
| 2.Check engine cooling system/heater hose connections for leaks. |
| 3.Check coolant level and antifreeze protection level; add coolant if necessary. |
| 4.Check level of brake and clutch fluid in reservoir; add fluid if required. |
| 5.Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary. |
| 6.Check air conditioner for operation. |
| 7.Reset Service Indicator. |
| Body/Electrical Equipment |
| 1.Check battery electrolyte level and add distilled water if required. |
| 2.Perform batter load test. |
| 3.Check lighting system, i.e. headlights, foglights, parking, backup, license plate, interior (including map reading lights), glove box, flashlight, illuminated makeup mirrors, luggage compartment lights. |
| 4.Check instrument panel and dashboard illumination. |
| 5.Check all warning/indicator lights, check control. |
| 6.Check turn signals, hazard warning flashers, brake lights, horns, headlight dimmer/flasher switch. |
| 7.Check wiper and washer system(s); wiper blades, washer jet positions. |
| 8.Check condition and function of safety belts. |
| 9.Oil hood, trunk/tailgate, and door hinges. |
| 10.Grease hood, trunk/tailgate and door latches. Check operation of all latches. |
| 11.Check central locking/double lock. |
| 12.Replace microfilter or Acc. Cabin Filter. |
| 13.Check heater/air conditioner blower, rear window defogger. |
| 14.Check rear view mirrors |
| 15.Visually examine the SRS airbag units for torn cover, obvious damage or attachment of decals, decorations, or accessories. |
| Final Inspection |
| Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission |
| Inspection II |
| Undercarriage |
| 1.Change engine oil and filter while engine is at normal operation temperature. |
| 2.Check transmission for leaks. |
| 3.Check rear axle for leaks. |
| 4.Visually check fuel tank, lines, and connections for leaks. |
| 5.Check condition, position, and mounting of exhaust system. Examine for leaks. |
| 6.Check power steering system for leaks. |
| 7.Check overall thickness of front and rear disc brake pads. |
| 8.Examine brake disc surfaces. |
| 9.Clean brake pad contact points in calipers. |
| 10.Grease wheel center hubs. |
| 11.Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc. |
| 12.Check front control arm bushing for wear. |
| 13.Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning. |
| 14.Check for free movement of the parking brake cables. Adjust parking brake if necessary. |
| 15.Check all tire pressures (including spare). Correct if necessary. |
| 16.Check condition of tires (outer surfaces (left/right)), tread wear and pattern; In case of uneven tread wear readjust wheel alignment if required. |
| 17.Check thickness of parking brake linings. |
| 18.Half-shafts; check for leaks at flexible boots. |
| 19.Inspect entire body according to terms of rust prevention limited warranty. |
| Engine Compartment |
| 1.Read out diagnostic system |
| 2.Check engine cooling system/heater hose connections for leaks. |
| 3.Check coolant level and antifreeze protection level; add coolant if necessary. |
| 4.Check level of brake and clutch fluid in reservoir; add fluid if required. |
| 5.Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary. |
| 6.Check air conditioner for operation. |
| 7.Check air conditioner for operation. |
| 8.Replace spark plugs. |
| 9.Replace intake air cleaner element. |
| Body/Electrical Equipment |
| 1.Check battery electrolyte level and add distilled water if required. |
| 2.Perform batter load test. |
| 3.Check lighting system, i.e. headlights, foglights, parking, backup, license plate, interior (including map reading lights), glove box, flashlight, illuminated makeup mirrors, luggage compartment lights. |
| 4.Check instrument panel and dashboard illumination. |
| 5.Check all warning/indicator lights, check control. |
| 6.Check turn signals, hazard warning flashers, brake lights, horns, headlight dimmer/flasher switch. |
| 7.Check wiper and washer system(s); wiper blades, washer jet positions. |
| 8.Check condition and function of safety belts. |
| 9.Oil hood, trunk/tailgate, and door hinges. |
| 10.Grease hood, trunk/tailgate and door latches. Check operation of all latches. |
| 11.Check central locking/double lock. |
| 12.Replace microfilter or Acc Cabin Filter. |
| 13.Check heater/air conditioner blower, rear window defogger. |
| 14.Check rear view mirrors |
| 15.Visually examine the SRS airbag units for torn cover, obvious damage or attachment of decals, decorations, or accessories. |
| Final Inspection |
| Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission |
| Oil Change Service |
| 1.Drain and refill your vehicle’s crankcase with BMW approved oil. Install a new genuine BMW oil filter |
| 2.Check all other Fluid levels, and top off as necessary. |
| 3.Check and adjust tire pressure. |
| 4.Fill windshield washer fluid. |
| 5.Reset oil light |
